Click here -> to return to the Table of Contents
Kentucky Electronic Claims Parameters
Menu Path:
MAINT/System Files/Telecom

Xcompa1.jpg (16888 bytes)
Screen 1
ê
wpe7.jpg (14148 bytes)
Screen 2
ê
wpe24.jpg (15574 bytes)
Screen 3 - Medicare Transmission Parameters



Medicare
Phone Number --
This is the phone number of the Medicare computer that receive the data transmission, and the number dialed by your MODEM. Note that in the screen(s) there is a comma between the 9 and the phone number. This is required if you dial 9 to get an outside line (the comma pauses after the 9 to receive a dial tone before proceeding with dialing the number). In some cases, several commas may be needed, and that will be dependent upon how long it takes to get an outside line.

Test Transmission <Y/N> -- If set to Y, certain parameters are changed in the electronics claim records transmitted so that Medicare recognizes the transmission as test claims. Initially it is necessary to submit test claims. These test claims will be scrutinized for determination of either re-testing or putting on a permanent basis. After successful testing, change from Y(es) to N(o).

MODEM BAUD Rate – either the max for your MODEM or max allowed for Medicare/Medicaid – note – may be different for Medicare and Medicaid

MODEM COM Port – depends upon your hardware configuration

Kentucky Remote ID, RMT -- Kentucky Processor ID -- Assigned by Medicare

Medicaid
Electronic claims not implemented at this time -- file via HCFA1500 form